Ny Dstar satelitt

I dag tidlig ble D-STAR ONE skutt opp.
D-STAR ONE er en amatør radio satellit med D-STAR ombord.

D-Star ONE (DP1GOS) halfduplex repeater & beacon frequencies:
Uplink: 437,325MHz
Downlink: 435,525MHz
RF-Power: 800mW

D-Star One is a 3U CubeSat which is equipped with four identical radio modules with D-Star capabilities, all being operated in a half-duplex mode.

Two modules are used for telemetry and telecomand and operate on identical frequencies. Telemetry can be received on 435,7 MHz, the format will be disclosed after launch. Both modules receive, and both modules answer. To prevent information loss, they answer after each other. So each telemetry frame is repeated twice. Both modules have a D-Star Voice-Message Beacon, but it is only activated for one module during LEOP. The Beacon is repeated once in a minute.

The other two modules are dedicated to the radio amateur community. Both modules have the same frequencies, so one of them will be powered down as long as the other one shows no degradation effects. The downlink frequency is 435.525 MHz and the uplink frequency is 437.325 MHz. Also here half-duplex mode is applied. The modules are configured to work as D-Star repeaters, so they retranslate the received d-star frames on the downlink frequency. They also have a D-Star voice beacon signal.

All modules are operated in a power save mode. This means that they are in idle for 40 seconds and then in receive mode for 20 seconds. Once a signal has been received, the modules switch to receive mode for five minutes. So it might be necessary to „ping“ the satellite a couple of times until an answer is received.
Mer informasjon her: http://www.d-star.one/

En kommentar om “Ny Dstar satelitt

Legg igjen en kommentar